specializes in hard to find NGK products. We are not NGK Spark Plugs USA. To contact them, click here.

NGK Plug Torque Settings

It is essential to tighten a spark plug to the specified turning angle or torque setting as torque directly impacts a spark plugs ability to remove heat from the combustion chamber. Over tightening can cause damage to the threads in the cylinder head and the threads of the spark plug, stress the spark plugs internal seal, or fracture the spark plugs insulator. Under tightening will prevent the spark plug from being properly seated on the cylinder head, resulting in insufficient contact with the head to transfer heat. Either of these would result in elevated combustion chamber temperatures, followed by pre-ignition and detonation.

Proper Tightening Procedure

Clean the spark plug threads and ensure the cylinder head is clean of debris.

Screw in the spark plug finger tight until the gasket meets the cylinder head. Then tighten the plug as specified below: 

With a Torque Wrench:

To find NGK's recommended torque setting, please enter the spark plug number in the search box. While viewing the part detail page, click on the "specs" tab. If a recommendation has been made, it will appear under the "Specifications" heading.

Without a Torque Wrench:

Spark Plug Torque

If a torque wrench is unavailable, finger tighten the spark plug, then use a plug wrench to tighten.  1/2-2/3 turn on plugs with a gasket. 1/12-1/8 turn on plugs with a tapered seat.



  • Torque recommendations are for spark plugs with new gaskets.
  • If using anti-seize compound, use sparingly and reduce torque by 30%.
  • NGK has created their recommendations based on the general consensus of most engine manufactures. In the case of a discrepancy between the plug manufacturer and engine manufacturers recommendations, always default to the engine manufacturer.